High Voltage Electron Gun Mount
120KV Tri-pole Heat-Exchanger Assembly
Client – MIT Research Lab
- Customer required an assembly which incorporated 3 ceramic breaks into a water-cooled base mount for a High-Power Electron Gun. The E-gun mount must operate at 120KV and remain electrically isolated from the base flange. The entire assembly requires liquid coolant to circulate thru the base flange to the E-gun mount. Three ceramic-to-metal breaks were used to form a tri-pole assembly which isolated the base flange from the high voltage, and maintained a full hermetic barrier for the ultra-high-vacuum environment.
- Several dimensional tolerances regarding parallelism of sample flange to base flange, and locational tolerances for tapped holes and such on either.
- The sub-assemblies required highly tolerance ceramic tubes, and careful fixturing to keep ends parallel.
- Post-braze machining of the weld adapters was required to fit the flanges into the assembly and maintain parallelism of the plates.
- MPF considered ceramic break design for sub-assemblies which would withstand 130KV and provide structural support for the sample flange. These sub-assemblies would be brazed with weld cuffs, such that the 3 subs would then be assembled into the overall assembly using TIG welding.
- The assembly was completed to exact specifications, and MPF was able to provide additional spare sub-assemblies (breaks with weld adapters). MIT installed the Heat-Exchanger in their system and proceeded with expected operations.